What is the status quo of airtight building in Germany? Are we well on our way or still far from the target? What about measuring practice in Germany? Should we concentrate on the documentation of measurement results or is it more important to exert a positive influence on the building process overall? Which requirements and targets...

I have already talked about the issue of airtightness designs in Swiss standards at the Buildair Conference in 2015. What are the challenges we are facing two years later, regarding airtightness in Switzerland? And which of the issues in this context could be of interest for other countries...

When building is set on very low negative pressure, use the Radon sniff-equipment called RAD7 to count radon at places where thermal imaging camera tell there is draft that can be assumed tob e leaks from the ground. If the found leakages are from the ground it often show higher level of Thoron, Radon and Polonium values, than the...

It has been ten years since the publication of a draft proposal, and now, many hundred measurements without a binding standard for such a sensitive area later, the day has finally come. We have a standard dealing exclusively with the airtightness of clean rooms. The presentation shows the way to the new VDI 2083/19 and...

Since 2008 in France, all measurement of building envelope airtightness performed according to the EP-regulations have to be performed by a certified operator. This certification includes a yearly follow-up we use to build up a highly detailed database which includes data of about 90,000 airtightness measurements...

To describe the effectiveness of the thermal anemometer device in assisting airtightness testers to evaluate leakage zones, and specific leakages. There are two main aspects: While the building is pressurised to 50Pa use is made of internal doorways to close off each room to make a 'zone', and an airspeed reading is taken...

Over the past years, the industry has launched a great number of products facilitating the airtight installation of sanitary fixtures in the airtight building envelope. However, the pre-wall mounting racks of cisterns remain a “key point” for assessing the airtightness of pre-walls. As part of the rehabilitation of an indoor swimming pool, “airtight”...

Airtightness/air permeability are inseparable from leakages and their detection, categorization, or evaluation. The diverse contexts due to the main construction methods, structures, materials used, individual conditions on site for each building, and the perspectives of the different disciplines regarding airtightness, make it hard to take quick...