Skip to main content

International Building Simulation Conference 2005, Montreal, Canada.

Contains 180 papers.

Volume content
Reducing building operational cost through environmental efectiveness ratios

The introduction of EU directives 2002/91/EC and 2003/87/EC both prompt a reduction in energy consumption from European buildings. Buildings account…

 James O'Donnell, Elmer Morrissey, Marcus Keane, Brian O' Gallachoir, Vladimir Bazjanac,
The use of simulations to support the retrofitting of a dutch monastery,listed as a historic building and being re-used as an office building

This paper describes the use of simulations to support the renovation process of a monastery, that is listed as an historic building and is being…

Laure Itard, Hans Boender, Wiebe Zoon
Simulation strategy and sensitivity analysis of an in-floorradiant heating model

Heating Canadian homes is an energy intensive endeavour. Factors such as the northerly climate and dispersed population cannot be avoided but…

J. Good, V.I. Ugursal , and A. Fung
The application of shading masks in building simulation

Calculating the dynamic effects of surface overshadowing is a major part of most thermal analysis engines. It also represents a significant…

Andrew Marsh
Review and recommendations for improving the modelling of building integrated photovoltaic systems

The models for photovoltaic (PV) systems currently in ESP-r prove very useful in estimating the electrical and thermal impact of building-…

Didier Thevenard
Thermal mass, insulation and ventilation in sustainable housing – an investigation across climate and occupancy

Sustainable housing standards are reviewed including the UK 2005 building regulations, the UK Advanced Standard and EU Passive-house Standard.…

Paul Tuohy, Lori McElroy, Cameron Johnstone
Simulation-based automated commissioning method for air-conditioning systems and its application case study

This paper proposes an automated commissioning method for air-conditioning systems through comparing the measured energy consumption with the…

Fulin Wang1, Harunori Yoishida, Satoshi Masuhara, Hiroaki Kitagawa, Kyoko Goto
The architects approach to the project of energy efficientoffice buildings in warm climate and the importance of designmethods

This article aims at a better understanding of how decisions are taken to improve energy performance of office buildings in warm climates and why…

Aldomar Pedrini, Steven Szokolay
Simplified model-based optimal control of VAV air conditioningsystem

A simplified optimization process (SOP) for determining set points is proposed and evaluated using the monitoring data and model of an existing…

Nabil Nassif, Stanislaw Kajl, and Robert Sabourin
Toward a unified information space for the specification of building performance simulation results

We present a framework for the specification of building performance simulation output results. Toward this end, we describe a simulation output…

Ardeshir Mahdavi, Julia Bachinger, Georg Suter
Simulation-based design by hierarchical optimization

This paper critically examines the use of Analytic Target Cascading as a multi-level, hierarchical design optimization model for formulating …

Ruchi Choudhary, P.Y. Papalambros, Ali M. Malkawi
The development of a test protocol for anon-line whole-building energy analysis tool for homeowners

This paper presents the testing of a dynamic on-line whole-building energy calculator. The Home Energy Analyser is intended for use by the…

Julia Purdy, Phylroy Lopez, Kamel Haddad, Alex Ferguson, Stephanie Mombourquette, Paul Wyndham-Wheeler, Shawn Henry
Simtest-elec: a virtual laboratory for the test of terminal controllers for electric heating systems following a draft European standard

CEN TC247 has prepared draft standards for main types of room controllers. These standards include a performance testing procedure that was…

P. Riederer, F. Bruyat, B. Clémençon, S. Bernasconi, G. Desjardins
Transferring simulation from specialists into design practice

Building simulation tools (energy, lighting, plant simulation, CFD, etc) have long been the preserve of a few specialist consultancies rather than being…

Iain A Macdonald, Lori B McElroy, Jon W Hand, Joe A Clarke
Simulation-based design procedure to evaluate hybrid renewableenergy systems for residential buildings in Korea

Energy and environment issues such as the reduction of greenhouse gas emissions and ecological-friendly buildings are increasingly of interest in the…

J. Clarke, J. Hong, J. Kim, P. Strachan, I. Hwang, H. Lee
The numerical modelling of the diffusive-convective watervapour transport through the building constructions

The following paper is focused on the effects of the combined water vapour transport caused by diffusion and convection. The governing equation of…

Zbynek Svoboda
Simulating tall buildings using energyplus

Tall buildings pose unique challenges for simulation software and modelers. Environmental factors such as air temperature and wind speed …

Peter G. Ellis and Paul A. Torcellini
Two DOE-2 functions

This paper presents two DOE-2 functions to expand the modeling capability of DOE-2.1E, a popular calculation engine for building energy…

Tianzhen Hong, Charles Eley, and Erik Kolderup
Sky luminance mapping for computational daylight modeling

Building design and control applications can benefit from daylight simulation. Currently, most daylight simulation applications work with simplified…

Bojana Spasojević and Ardeshir Mahdavi
Performance comparison of heating control strategiescombining simulation and experimental results

Different heating system controllers for passive solar buildings are compared on two different buildings. The performance criterion combines…

Michaël Kummert, Philippe André, Athanassios A. Argiriou
Showing 21 to 40 of 180. Page 2 of 9