Skip to main content

International Building Simulation Conference 2013, Chambéry, France. 

Contains 470 papers.

Volume content
Preprocessor for the generation of g-functions used in the simulation of geothermal systems

The objective of this paper is to present a general methodology for the calculation of thermal response factors, known as g-functions, of vertical borehole…

Massimo Cimmino, Michel Bernier
Renato Lepore, Christine Renotte, Marc Frere3, Eric Dumont
Developing a system dynamics based building performance simulation model – SdSAP to assist retrofitting decision making

Retrofitting our current building stock is a vital part of meeting emissions reductions targets, using energy in a more efficient way and creating…

Yangang Xing, Simon Lannon, Malcolm Eames
A two-staged simulation model calibration approach to virtual sensors for building performance data

In existing buildings, monitored data can support the process of simulation model calibration and validation. Such calibrated models could be effectively…

Farhang Tahmasebi and Ardeshir Mahdavi
Generation of weather files using resampling techniques: an exploratory study

Simulating a building to predict its performance over the course of a full year requires an accurate repre-sentation of the stable and representative…

Parag Rastogi, Marilyne Andersen
Using general modeling conventions for the shared development of building performance simulation software

The building performance simulation community ap-plies theory from several different fields to develop models for heat transfer, light propagation, human be-…

Rhys Goldstein, Simon Breslav, Azam Khan
Calibration of an EnergyPlus central cooling plant model with measurements and inter-program comparison

This paper, which is an extension of previous studies, presents the modeling of an existing central cooling plant by using the EnergyPlus program. The…

Danielle Monfet, Radu Zmeureanu
Valentina Fabi, Rune V. Andersen, Stefano P. Corgnati
Simulation of the impact of aquifers on the ground temperature in ground-source heat pump operation

The winter operation of ground-source  heat pumps is expected to lead to drift phenomena in the zones surrounding the vertical ground heat exchangers.…

Antonio Capozza, Angelo Zarrella
Model based failure mode effect analysis on whole building energy performance

It is a known fact that fault in the buildings can cause as much as 30% increase in energy consumption. Thus, identifying critical failure modes affecting…

Ritesh Khire, Marija Trcka
Assessing the simulation capability of the accurate engine in modelling massive construction elements

Simulation is often utilised in the regulatory assessment of building performance as in the case of the Australia’s Nationwide House Energy Rating Scheme (…

Lyrian Daniel, Veronica Soebarto, and Terence Williamson
CFD simulation of micro-climate in waterfront

As an important influence factor of unban climate, unban water bodies take positive effect on the micro-climate of surrounding area in summer. This paper…

Xiaocheng, Song, Jing, Liu
Impact of shading control and thermostat set point control in perimeter zones with thermal mass

This study is focused on the impact of shading control and thermostat set point control on daylighting metrics, glare evaluation and energy consumption for…

Ying-Chieh Chan, Athanasios Tzempelikos
Intelligent zone controllers: a scalable approach to simulation-supported building systems control

This paper describes the concept of an intelligent zone controller for the efficient operation of environmental systems in buildings. This controller…

A. Mahdavi, M. Schuß
A sensitivity study of building performance using 30-year actual weather data

Traditional energy performance calculated using building simulation with the typical meteorological year (TMY) weather data represents the energy…

Tianzhen Hong, Wen-Kuei Chang, Hung-Wen Lin
Showing 401 to 420 of 470. Page 21 of 24